Brake testing on test stand - AP42.00-P-4290R

MODEL 211, 230, 240 

MODIFICATION NOTES

19.1.04

Step "Check free travel of service brake pedal" removed.

	Check
1	Check version of parking brake pedal assembly
		Parking brake pedal assembly modified	BT42.20-P-0510-01A
2	Press parking brake pedal	If the parking brake pedal travel is outside the specified value, adjust the parking brake.
		Model 211	AR42.20-P-0540T
		Model 230	AR42.20-P-0540R
		Model 240	AR42.20-P-0540H
		Actuating force on parking brake pedal	*BE42.20-P-1001-01C
		Notches through which the parking brake pedal must be depressed	*BE42.20-P-1002-01C
3	Measure the deceleration values of the parking brake on the brake test stand.	Permissible deviation from the higher value: maximum 50 %. Braking effect of parking brake uneven or insufficient: ↓
		Bed in parking brake according to instructions.	AP42.20-P-4290-01BA
4	Measure deceleration values of service brake on test stand.	Permissible deviation from the higher value: maximum 25 %.
5.1	Read out fault memory	Only carry out if after a run on the brake dynamometer one of the indicator lamps of ABS, BAS, ESP or SBC lights up when the engine is running. The indicator lamps can light up if brake dynamometers are operated > 5 Km/h. Cause: implausible rpm signals due to different rotational speeds at the front and rear axle.
	Connect diagnosis testing equipment		AD00.00-P-2003A

PARKING BRAKE ADJUSTMENT VALUES

Number	Designation		Model 211, pedal assembly with pulled notch	Model 211, pedal assembly with pushed notch
BE42.20-P-1001-01C	Actuating force on parking brake pedal	N	130 (±50)	130 (±50)
BE42.20-P-1002-01C	Notches through which the parking brake pedal must be depressed	Quantity	1	5
		See fig.	BT42.20-P-0510-01A	BT42.20-P-0510-01A

ADJUSTMENT VALUES FOR PARKING BRAKE

Number	Designation		Model 230, pedal assembly with pulled detent	Model 230, pedal assembly with pushed detent
BE42.20-P-1001-01C	Actuating force on parking brake pedal	N	170 (-50/+70)	170 (-50/+70)
BE42.20-P-1002-01C	Notches through which the parking brake pedal must be depressed	Quantity	1	5
		See fig.	BT42.20-P-0510-01A	BT42.20-P-0510-01A

ADJUSTMENT VALUES FOR PARKING BRAKE

Number	Designation		Model 240, pedal assembly with pulled notch	Model 240, pedal assembly with pushed notch
BE42.20-P-1001-01C	Actuating force on parking brake pedal	N	170 (-50/+70)	170 (-50/+70)
BE42.20-P-1002-01C	Notches through which the parking brake pedal must be depressed	Quantity	1	5
		See fig.	BT42.20-P-0510-01A	BT42.20-P-0510-01A