Service-Information: Sensotronic Brake Control (SBC) - SI42.46-P-0001D

MODELS 211, 230 

Maintenance and repair on SBC brake control:

The published workshop documents (WIS) specify that only trained workshop personnel should be permitted to perform maintenance and repair work on the SBC. We would like to qualify this somewhat and make it more transparent.

Workshop employees who have completed the following training measures or courses of instruction may perform maintenance and repair work on the SBC:

1. Introduction training, model 230 (PESL/PFSC)
2. Introduction training, model 211 (PEEG)
3. Special training (PFSB)
4. Specialist training (PFSD)

Workshop employees and service technicians who have participated in the courses of training specified can act as multipliers in the workshops.

Trainers who have participated in the courses of training specified can also act as multipliers in training other employees.

Further measures are not required.

Naturally, all safety precautions should be observed.