Weld in longitudinal member cover - AR62.20-P-1260-04P

WARNING: This page is about a different car, the 2009 Mercedes-Benz CLK350 and 2008 Mercedes-Benz CLK350. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Longitudinal Member Cover Welding Area (E, F & G)

Courtesy of MERCEDES-BENZ USA

Work procedure shown on model 203.0.

Fit longitudinal member cover.
Install longitudinal member cover and fasten.
Weld in longitudinal member cover with (areas F and G).
Weld in longitudinal member cover with (area E).
Do not grind MIG weld down flat for reasons of stability (area E).
Coat insides of spot weld flanges with zinc dust paint.

Fig 2: Identifying Longitudinal Member Cover Welding Area (A, B & C)
Courtesy of MERCEDES-BENZ USA
Weld in longitudinal member cover with (areas A, B and C).
Clean weld joints using wire brush.
Remove shavings using wet/dry vacuum cleaner.