Remove/install tilting rear seat - AR91.12-P-1720Q

MODEL 209.3 except CODE (P98) Black Series 

Fig 1: Identifying Tilting Rear Seat Components (1 Of 3)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Tilting Rear Seat Components (2 Of 3)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Tilting Rear Seat Components (3 Of 3)

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove side upholstery		AR91.12-P-1710P
2	Unclip seat adapter (1)	Lay sealing felt aside and pull seat adapter forwards at the clips (2).
3	Move seat adapter (1) out of retaining tab (3)	Press to the rear in the center.
4	Remove seat adapter (1)
5	Unscrew nuts for bearing bracket (4)		*BA91.12-P-1003-03C
6	Release and tilt 1/3 rear backrest (6), 2/3 rear backrest (7)
7	Remove cover behind rear seat		AR68.30-P-4600PB
8	Unscrew nuts for bearing bracket (4)		*BA91.12-P-1003-03C
9	Remove pneumatic connection (5).
10	Remove 2/3 rear seat backrest (7)	Do not damage 1/3 rear seat backrest (6). 1/3 rear seat backrest (6) must be tilted. Lift 2/3 rear seat backrest (7), swivel bearing bracket upward and pull 2/3 rear seat backrest (7) down from left bearing bolt (8).
11	Remove pneumatic connection (5).
12	Take out 1/3 rear backrest (6)	Lift 1/3 rear backrest (6) and pull down from right-hand bearing bolt.
13	Unscrew bearing bolt screws (9)	Only if outer bearing pin at wheel arch damaged.	*BA91.12-P-1001-03C
14	Install in the reverse order

REAR SEATS

Number	Designation		Model 209
BA91.12-P-1001-03C	Outer bearing pin bolt at wheel arch	Nm	23 (±3)
BA91.12-P-1003-03C	Inner bearing bracket nut to floor of vehicle.	Nm	40