Remove rear seat and rear backrest - AR91.12-P-1700QA

MODEL 209.4 

Fig 1: Identifying Rear Seat And Rear Backrest Components Location (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Rear Seat And Rear Backrest Components Location (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Remove/Install
	Injury hazard from rollover bar extending	Manually remove rear head restraints before working in vicinity of roll bar.	AS91.00-Z-0003-01QA
1	Lower convertible top and leave soft top compartment cover open
2	Move both front seat forward
3	Remove covers (5)
4	Unscrew nuts (6) from rear seat cushions (1 and 2)
5	Remove rear seat cushions (1 and 2) - pull out to front
6	Unscrew nuts (7) from rear center console (4)
7	Detach connector (8) from rear center console (4) and remove
8	Unscrew screws (9)	Screw on belt end fitting	*BA91.40-P-1001-01A
9	Loosen nuts (10)
10	Disconnect connector (12)
11	Pull rear seat backrest (3) forward and then remove from above, guiding seat belt through plastic eyelet (11)
12	Install in the reverse order

SEAT BELTS/EMERGENCY TENSIONING RETRACTORS

Number	Designation		Model 209
BA91.40-P-1001-01A	Belt end fitting screw	NM	30