Remove paneling in trunk - AR68.30-P-4600QA
MODEL 209.4
| Remove/Install | |||
|---|---|---|---|
| 1 | Open trunk lid | ||
| 2 | Remove trunk floor paneling (1) | ||
| 3 | Remove spreading clip (3) and clip (4) from bottom rear center section paneling (2) | ||
| 4 | Remove bottom rear center section paneling (2) | ||
| 5 | Unclip clip (4) from left side wall paneling (8) | Fig 2 | |
| 6 | Unclip threaded clip (11) from left side wall paneling (9) | ||
| 7 | Remove left side wall paneling (8), disconnect connector for trunk illumination (12) | ||
| 8 | Unclip clip (4) from right side wall paneling (8) | ||
| 9 | Unclip threaded clip (11) from right side wall paneling (10) | ||
| 10 | Remove right side wall paneling (10) | ||
| 11 | Unclip clip (4) from cross member paneling (6) | ||
| 12 | Open soft top compartment cover | ||
| 13 | Cover vehicle in rear area | ||
| 14 | Remove retractable trunk partition | AR68.50-P-3000QA | |
| 15 | Unscrew bolts (13) from separation centering bracket (14) | ||
| 16 | Remove separation centering bracket (14) | ||
| 17 | Unclip clip (4) from cross member paneling (6) | ||
| 18 | Remove cross member paneling (6) | ||
| 19 | Unscrew plastic nuts (19) | ||
| 20 | Remove left base bracket (15) | ||
| 21 | Unscrew threaded clip (11) from left soft top compartment paneling | ||
| 22 | Unclip clip (4) from left soft top compartment paneling (7) | ||
| 23 | Remove left soft top compartment paneling (7) | ||
| 24 | Unscrew plastic nuts (19) | ||
| 25 | Remove right base bracket (16) | ||
| 26 | Unscrew threaded clip (11) from right soft top compartment paneling | ||
| 27 | Unclip clip (4) from right soft top compartment paneling (8) | ||
| 28 | Remove right soft top compartment paneling (8) | ||
| 29 | Open ski bag (18) and unscrew bolts (17) | ||
| 30 | Remove ski bag (18) | ||
| 31 | Unclip clip (4) from ski bag rear wall paneling (5) | ||
| 32 | Remove ski bag rear wall paneling (5) | ||
| 33 | Install in the reverse order |