Connect wiring harness - AZ82.20-P-0001-02Q

Wiring harness connection schematic illuminated door sill molding

Fig 1: Wiring Harness Connection Schematic Diagram

Crimp the two connecting lines of the wiring harness of the illuminated door sill molding (6) into the cable lug (20) and then put in the fuse holder (21).

Fig 2: Identifying Cable Lug And Fuse Holder
Connect wiring harness (6) with fuse holder (21) to a free plug position (arrow) at the rear SAM control module with fuse and relay module (N10/2).
Fit fuse holder 21 with a 7.5 A fuse.

Fig 3: Identifying Wiring Harness And Fuse Holder
Route wiring harness (6) along existing lines in trunk as shown in figure.

Fig 4: Identifying Wiring Harness Along Existing Lines
Connect brown ground line to ground connection (arrow).

Fig 5: Locating Ground Connection
Route branch-off line for the illuminated door sill molding in the cable duct on right and left driver door.
Slip on inverter (3) and insert in the cable duct.

Fig 6: Identifying Inverter
Set door sill molding line with adhesive tape (arrows) below the door sill molding as shown in figure.

Fig 7: Locating Adhesive Tape
Put the appropriate door sill molding to each door concerned and drill a ø 6 mm hole (arrow) into the weatherstrip fold of the rocker panel at the level of the appropriate line terminal and varnish.
Drill hole as close to the lower weatherstrip fold as possible.

Fig 8: Locating Drill Hole
Clip in illuminated door sill molding and route the connecting line (11) through the drilled hole.
To do this, pin out connecting line (11).
Insert 2 pins of the connecting line (11) into a connection coupling housing (4) and connect to wiring harness (6).

Fig 9: Identifying Wiring Harness, Connecting Line And Coupling Housing
At each door concerned connect the two-color line of the door contact to attached clamp joint at the identically colored branch-off line of the wiring harness (6).

Fig 10: Identifying Wiring Harness