Removing and installing front door side airbag - AR91.60-P-0690M

MODEL 215, 220 

Illustrated on model 220 

Fig 1: Identifying Front Door Side Airbag Remove/Install Components - Illustrated On Model 220

	Removal, installation
	Injury hazard  when testing or repairing airbags or emergency tensioning retractors	Store airbags with opening surface pointing up, do not expose to temperatures above 100 °C. Interrupt electric circuit when working on these units	AS91.00-Z-0001-01A
	Evaluation of airbags and emergency tensioning retractors on accident vehicles		AH91.00-P-0006-01B
	Important instructions for performing repair, body work and welding on vehicles with airbags and emergency tensioning retractors		AH91.00-P-0002-01M
	Legal regulations on handling and storing airbags and emergency tensioning retractors		AH91.00-P-0004-01A
1	Remove ignition key
2	Remove door liner on front door	Model 215	AR72.10-P-1000N
		Model 220	AR72.10-P-1000M
		Installation:  Replace door liner center section with side airbag triggered
3	Disconnect connector on left and right side airbag squibs (R12/9 and R12/10)	Installation:  Connector should catch audibly
4	Drill out rivets (1) on side airbag (2) retaining plate (3)	Installation:  For mounting use rivet, part no. 003 990 24 97
5	Remove side airbag	Disposal:  When side airbag is replaced dispose of defective part properly: ↓
	Instructions on disposal of airbags and emergency tensioning retractors		OS91.00-P-0001-01A
	Rendering airbags unusable		AR91.60-P-0611A
6	Install in opposite order
7	Perform diagnosis	Star diagnosis