Remove/install spring link and replacement of rubber mount - AR35.20-P-0114MB

MODEL 220.175 /178 with CODE (Z07) Top protection

Fig 1: Identifying Spring Link Remove/Install Components - Model 220.175 /178 With Code (Z07) Top Protection

	Remove/Install
	Risk of death cased by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
	Risk of injury caused by pinching or jamming when working on loaded springs or spring bodies	Use only approved clamping devices; shield off hazard area if necessary. Inspect special tools for damage and proper operation (visual inspection). Wear protective gloves.	AS00.00-Z-0001-01A
Installation	Replace self-locking nuts and bolts
1	Raise vehicle.
2	Tension rear spring (73)		AR32.20-P-0200-06MB
		Tensioning device	*202589013100
		Tensioning plates	*202589136300
3	Detach spring strut (41) from spring link (6)		*BA32.25-P-1005-04B
4	Detach spring link (6) from wheel carrier	Installation: The rear axle shaft must be horizontal when tightening the nut.	*BA35.20-P-1002-01B
5	Detach spring link (6) from rear-axle carrier	Installation: The rear axle shaft must be horizontal when tightening the nut.	*BA35.20-P-1001-01B
6	Remove spring link (6) together with rear spring (73)	Clean spring link in contact area. After replacing the rear spring or the rubber mount ↓
		Check and correct headlamp adjustment	AP82.10-P-8260A
7	Remove rear spring (73)		AR32.20-P-0230MB
	Check
8	Inspect spring link rubber mount (6b) in rear axle carrier	↓ If necessary after checking:
		Remove and instal spring link rubber mount	AR35.20-P-0114-01I
		Press	Figure
		Removal and installation tool	Figure
9	Install in the reverse order