Removing and installing fiber optic cable - AR82.70-P-0004MA: Notes

MODEL 215, 220 

Between COMAND or radio/left side of trunk 

Illustrated on model 220 

Removing fiber optic cable M1 

Fig 1: Fiber Optic Cable Diagram - Illustrated On Model 220

	Removal, installation
	Notes on fiber optic cables		AH82.70-P-0001-02A
1	Disconnect ground lead from battery		AR54.10-P-0003I
2.1	Remove radio	Model 215	AR82.60-P-7502N
		Model 220	AR82.60-P-7502I
2.2	Remove operating, display and control module	Model 215 with code 352a	AR82.85-P-7472N
		Model 220 with code 352a	AR82.85-P-7472I
3	Remove floor cover in rear	Model 215	AR68.20-P-4800N
		Model 220	AR68.20-P-4800M
4	Open left wiring duct
5.1	Remove rear seat backrest		AR91.12-P-1620MA
5.2	Remove rear seat backrest	Model 220 with bucket seats (code 401), left side only	AR91.12-P-1620M
6.1	Remove seat adjustment device	Model 220 with bucket seats (code 401), left side only	AR91.10-P-1450M
7	Remove paneling in trunk	Left paneling and on rear wall	AR68.30-P-4600M
8	Remove rear wall in trunk
9	Cover fiber optic cable	Do not kink or stretch fiber optic cable D2B  Install caps on fiber optic cable connector and module connection	AR82.95-P-0005-01A
10	Leave fiber optic cable module disconnected		AR82.70-P-0004-01A
11	Install in opposite order
12	Start up and check for proper function