Removing and installing Keyless Go antenna - AR82.62-P-8000MD

MODEL 215, 220 with CODE (889) Keyless Go in trunk 

Illustrated on model 220 

Left side 

Fig 1: Identifying Keyless Go Antenna Remove/Install Components - Model 220 (Left Side)

Right side 

Fig 2: Identifying Keyless Go Antenna Remove/Install Components - Model 220 (Right Side)

	Removal, installation
1	Remove paneling in trunk	Right side, remove right side paneling only	AR68.30-P-4600M
2	Release and remove electrical connector (1) from Keyless Go control module (N69/5)
3	Press locks on left and right antenna elements (A2/35a1, A2/35a2) in trunk in direction of arrow and remove left/right antenna elements (A2/35a1, A2/35a2)	Observe wire routing
4	Install in opposite order