Removing and installing rear rubber mounts in rear axle center assembly mounting - AR35.10-P-0050-02I

Fig 1: Identifying Extraction And Insertion Tool (210 589 02 43 00)

Removing rubber mounts 

1. From the front, measure and note down press-in depth of jacket of both rubber mounts (62) in rear axle carrier using a depth gauge.
   Fig 2: Identifying Rubber Mounts

   
2. Pull both rubber mounts (62) out of rear axle carrier. To do this, use sleeve (062p), thrust piece (062q) and bolt 117mm long.
   Fig 3: Identifying Rubber Mount - Design

   

   Installing rubber mounts 

   

   Insert rubber mounts into rear axle carrier from the front so that the smooth surface (arrow) is facing the front.

   Fig 4: Locating Rubber Mount

   
3. Pull both rubber mounts (62) into rear axle carrier from front to rear until the previously measured press-in depth is obtained. To do this, use thrust piece (062q), sleeve (062I) and bolt 146mm long.
   Fig 5: Identifying Rubber Mount - Design

   
4. Check press-in depth of rubber mounts (62) and correct if necessary, see step  3.
   Fig 6: Identifying Rubber Mounts