LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2004 >> CL500 >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes -- Testing & Repair -- 215 & 220 Chassis >> Testing & Repair >> Making holes for bracket of parking brake cable on rear axle carrier - AR42.20-P-2001-01I

Making holes for bracket of parking brake cable on rear axle carrier - AR42.20-P-2001-01I

TORQUE SPECIFICATION REAR AXLE SHAFT

Number Designation Model 215 Model 220
BA35.30-P-1002-01A Self-locking bolt, rear axle shaft to connecting flange (thread and bolt head contact surface oiled) M10 Nm 70 70
M12 Nm 100 100
WORKSHOP EQUIPMENT

WE58.40-Z-1030-11A Transmission jack
  1. Position bracket (1) on rear axle carrier (2) and mark holes.

    IMPORTANT Attach new bracket (1) in parallel with the broken off bracket (1), displaced in the direction of the wheel.

    Fig 1: Identifying Bracket And Rear Axle Carrier
    G04849519
  2. Support exhaust system using a transmission jack.
  3. Unhook rubber mount (3) and lower the exhaust system.
  4. Detach rear axle shafts (37) from rear axle center assembly (50) and place downwards.
    Fig 2: Identifying Rubber Mount, Rear Axle Shafts And Rear Axle Center Assembly
    G04849520
  5. Center punch markings on rear axle carrier (2) and drill using angular drill (01) and 6.5 mm dia. drill.
  6. Debur holes.
  7. Mount rear axle shafts (37) on rear axle center assembly (50) TORQUE SPECIFICATION
  8. Hook up exhaust system in rubber mount (3).
    Fig 3: Identifying Rear Axle Carrier And Angular Drill
    G04849521
scientia non olet · About LEMON Manuals