Drilling template for rear side window sun shade - AN68.50-P-0002-01MB

Model 220.128/165/170/175/178 except code 979 

1. Mark template and cut out

   Reflect template for right side.

   Fig 1: Drilling Template For Rear Side Window Sun Shade Dimension - Model 220.128/165

   
2. Fit hole to mount as shown in drawing.

   Do not cut out hole too large, protective cap overlaps slightly

   Reflect template for right side

   Fig 2: Identifying Template For Left Guide Rail Cutout And Front Of Vehicle

   

   Cut out cutouts on left door frame paneling: 

3. Glue in template for left mount cutout (A) between stay (S/3) and stay (S/4) of left door frame paneling (2) and cut shaded areas out of left door frame paneling (2).
4. Remove template and deburr cutting edges.
   Fig 3: Identifying Stay Of Left Door Frame Paneling

   
5. Glue in template for left guide rail cutout (C) between stay (S/9) and stay (S/8) of left door frame paneling (2) and cut shaded areas out of left door frame paneling (2).
6. Remove template and deburr cutting edges.

   Cut out cutouts on right door frame paneling analogously.

   Fig 4: Identifying Left Door Frame Paneling