Extract rear axle shaft from rear axle center assembly, press in - AR35.30-P-0620-02PI

Pull out rear axle shaft 

1. Using a suitable tool (e.g. screwdriver, assembly lever), press rear axle shaft (37) out of the rear axle center assembly.

   When pressing out the rear axle shaft (37) do not damage the radial sealing ring to prevent leaks. Rear axle shafts (37) with damaged joints or boots must be replaced to guarantee proper functioning.

   Fig 1: Identifying Rear Axle Shaft And Joint Ring

   

Press in rear axle shaft 

2. Press in rear axle shaft (37) until circlip (37g) is felt to engage.

   Align the joint ring horizontally before inserting, otherwise the splined profile can tilt and become damaged during insertion.

   When pressing the rear axle shaft (37) into the rear axle center assembly do not damage the radial sealing ring to prevent leaks.

   The joint ring must close flush with the rear axle housing.

   Fig 2: Identifying Circlip