Radial sealing ring on side of rear axle housing and connecting flange modified - BT35.31-P-0013-01A

As of 01.04.98 k 

Rear axle center assembly dia. 185 in MODEL 124.003 /004 /007 /019 /022 /023 /026 /027 /030 /040 /042 /043 /050 /060 /062 /079 /082 /083 /090, 124.104 /107 as of 1.5.94, 124.127 /128 /129 /130 /131 /133 /188 /190 /191 /193 /226 /230 /290 /330 /333 /393, 129.060, 170.445 /447, 201.028 /029 /035 /036 /128, 202.020 /022 /023 /024 /025 /026 /028 /029 /080 /082 /083 /086 /089 /128 /188, 208.335 /345 /347 /435 /445 /447, 210.007 /010 /020 /035 /037 /061 /210 /235 /237 /261 /610 

Rear axle center assembly dia. 185 in MODEL 124.020 /021 /080 /081 /120 /125 /126 /180 /185 /186, 201.018 /023 /024 /122 /126 as of 1.11.88, 202.018 /078 /120 /121 /122 /125 /182, 210.003 /004 with CODE (450) Taxi version 

Rear axle center assembly dia. 185 in MODEL 124.186 as of 1.3.94, 202.134 /194 except CODE (450) Taxi version 

Rear axle center assembly dia. 185 in MODEL 202.085 with TRANSMISSION 722 

A new radial sealing ring and a new connecting flange with protection ring were phased in as of 01.04.98.

This improves the sealing at the connecting flange against dirt from outside.

If the new connecting flange  is installed, the new radial sealing ring  must also be installed. Only then is correct sealing guaranteed.

If the new radial sealing ring is installed, the previous connecting flange can continue to be used.

Version up to 31.03.98 

Version as of 01.04.98