Radial sealing ring and joint flange on drive pinion modified - BT35.31-P-0012-01B

As of 15.01.02 

Rear axle center assembly dia. in MODEL 124.003 /004 /007 /019185 /022 /023 /026 /027 /030 /040 /042 /043 /050 /060 /062 /079 /082 /083 /090, 124.104 /107 as of 1.5.94, 124.127 /128 /129 /130 /131 /133 /188 /190 /191 /193 /226 /230 /290 /330 /333 /393, 129.060, 170.444 /445 /447 /449, 201.028 /029 /035 /036 /128, 202.020 /022 /023 /024 /025 /026 /028 /029 /080 /081 /082 /083 /086 /087 /088 /089 /128 /188, 203.035 /045 /061 /235 /245 /261 /735 /745 /747, 208.335 /344 /345 /347 /348 /435 /444 /445 /447 /448, 210.010 /020 /035 /037 /048 /061 /062 /210 /235 /237 /248 /261 /262 /610 

Rear axle center assembly dia. 185 in MODEL 124.020 /021 /080 /081 /120 /125 /126 /180 /185 /186, 201.018 /023 /024 /122 /126 as of 1.11.88, 202.018 /078 /120 /121 /122 /125 /182, 210.003 /004 with CODE (450) Taxi version 

Rear axle center assembly dia. 185 in MODEL 124.186 as of 1.3.94, 202.134 /194, 203.004 /204, 210.007 except CODE (450) Taxi version 

Rear axle center assembly dia. 185 in MODEL 202.018 /120 /121 /125 with CODE (211a) Rear axle with automatic locking differential (ASD) 

Rear axle center assembly dia. 185 in MODEL 202.085 with TRANSMISSION 722 

A new radial sealing ring and a new joint flange with protection ring were phased in as of 15.01.02.

This improves the sealing at the drive pinion against dirt from outside.

Version as of 01.04.98 up to 14.01.02 

If repair work means that one of the two components (new joint flange or new radial sealing ring) is replaced for the first time, then both must be replaced together.

Only then is correct sealing guaranteed.

Version as of 15.01.02 with double labyrinth seal