Remove/install inner tie rod with axial joint - AR46.40-P-0201I

MODEL 203.004 /006 /016 /061 /064 /065 /076 /204 /206 /216 /235 /245 /261 /264 /265 /276 /706 /735 /745 /747, 209, 215.375 /376 /378, 220.026 /028 /063 /065 /070 /075 /125 /128 /165 /170 /175 /176 /178, 230

Shown on model 220

Fig 1: Identifying Inner Tie Rod With Axial Joint Remove/Install Components - Shown On Model 220

	Remove/install
	Risk of death caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
1	Remove front wheel
	Remove/install wheels, rotate if necessary		AP40.10-P-4050Z
2	Remove tie rod		AR46.40-P-0200I
3	Remove bellows		AR46.40-P-0400I
4	Counter gear rack (arrow)	Use open end wrench (width across flats 27 mm).
5	Remove inner track rod with axial joint (12)	Do not use force (hammer blows, severe leverage), use open wrench (012).
			*BA46.40-P-1003-01E
		Open-end wrench	Figure
6	Install in the reverse order

TIE ROD

Number	Designation		Model 203 except model 203.081/084/ 087/092/281/ 284/287/292	Model 209	Model 215	Model 220 except model 220.083/ 084/087/ 183/184/ 187
BA46.40-P-1003-01E	Inner track rod with axial joint to rack-and-pinion joint	Nm	110	110	110	110

TIE ROD

Number	Designation		Model 230
BA46.40-P-1003-01E	Inner track rod with axial joint to rack-and-pinion joint	Nm	110

Fig 2: Identifying Open End Wrench (201 589 00 01 00)