Solenoid valve 2-3 for shift mechanism - fault code description ME - AD07.61-P-4000-39L

		2-3 shift solenoid valve
1	Fault code ( Readout on generic scan tool)	P2060 (P0758)
2	Fault storage	After expiry of test duration and fault
	Actuation of the indicator lamp
	Engine diagnosis (EURO3/4)	No activation
	CHECK ENGINE (MIL)	Following two successive driving cycles with faults
3	Checking frequency	Continuous
4	Checked signal or status	Voltage supply
5	Fault setting conditions
	Short circuit to ground	Fault if the voltage is less than 0.4 volts.
	Lower limit value for voltage	Approx. 8.5 V
	Upper limit value for voltage	Approx. 15 V
	Lower limit value for current	Approx. 0,300 A flows.
	Upper limit value for current	Approx. 0,700 A flows.
	Checking duration	Approx. 1 second
6		Faults (actuation line discontinuity or short circuit, short circuit in valve) are recognized by the EGS control unit and reported to the ME control unit via the CAN data bus. Storage of faults and actuation of the CHECK ENGINE indicator lamp (MIL) are undertaken by the ME control unit. Also read out the EGS fault memory.