Inspecting belt pulley / vibration damper for axial and radial runout - AR03.30-P-1600-01GS

BELT PULLEY/VIBRATION DAMPER

Number	Designation			Engine 111
BE03.30-P-1001-02A	Permissible difference at vibration damper	Radial runout	mm	0.6
BE03.30-P-1001-02A	Permissible difference at vibration damper	Axial runout	mm	0.6

BELT PULLEY/VIBRATION DAMPER

Number	Designation			Engine 271
BE03.30-P-1001-02C	Permissible difference at vibration damper	Radial runout	mm	0.3
BE03.30-P-1001-02C	Permissible difference at vibration damper	Axial runout	mm	0.3

Fig 1: Identifying Dial Indicator (001 589 53 21 00)

Fig 2: Identifying Dial Indicator Holder (363 589 02 21 00)

Bolt dial gage holder (03) onto timing case cover.
Insert dial gage (04) into dial gage holder (03).
Check axial runout.
Position tracer pin (05) of dial gage (04) at measuring point (B).
Rotate belt pulley/ vibration damper (62) by hand, check axial runout.
Inspect concentricity.
Position tracer pin (05) of dial gage (04) at measuring point (A).
Rotate belt pulley/ vibration damper (62) by hand, inspect concentricity.

Fig 3: Inspecting Belt Pulley/Vibration Damper For Axial And Radial Runout