Removing and installing intake manifold - AR09.20-P-1310GB: Notes

ENGINE 111.943 /973 in MODEL 170 

ENGINE 111.944 /975 as of 1.9.96 in MODEL 202 

ENGINE 111.975 in MODEL 208 

ENGINE 111.947 in MODEL 210 

Fig 1: Identifying Intake Manifold Remove/Install Components - Engine 111.943 /973

	Removing, installing
1	Disconnect ground cable on battery, connect		AR54.10-P-0003A
	Risk of explosion  from ignition, risk of poisoning  from inhaling and swallowing fuel, as well as risk of injury  from skin and eye contact with fuel.	No fire, sparks, naked flames or smoking. Pour fuels only into suitable and appropriately marked containers. Wear protective clothing when handling fuel.	AS47.00-Z-0001-01A
2	Remove fuel rail together with injectors		AR07.03-P-1450D
4	Remove idle speed control (ISC) actuator, install		AR30.22-P-1152D
5	Disconnect or take off all vacuum lines and electric cables	Installation:  ↓
		Connect vacuum lines as shown in connection diagram	AR09.20-P-1310-01GB
6	Unclip fixture of engine wiring harness
7	Unplug sockets of crankshaft position sensor and knock sensor
8	Disconnect circuit 50 at starter
9	Slacken bolts (19/1) and take out intake manifold (19)		*BA09.20-P-1001-01B
		Installation:  Inspect gasket (19/3), replace if necessary
10	Install in the reverse order
11	Check idle speed, set	See Diagnosis Manual Engine, Volume 1/Index B

INTAKE MANIFOLD