LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2003 >> SLK320 Standard >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Electrical System, Equipment & Instructions -- 170 Chassis >> Retrofitting & Conversion >> Retrofitting ultrasonic backup assist - AZ54.65-P-0001G >> Installing instrument - AZ54.65-P-0001-05H

Installing instrument - AZ54.65-P-0001-05H

Model 170.4 

  1. Mark the center point of the mounting hole for the display instrument on the removed cover of the rear panel trim as per the diagram.
  2. Make a 30 mm dia. mounting hole at the marked drilling point and clip the display instrument (1) into the trim.
    Fig 1: Identifying Instrument Drilling Point Length
    G04743755
  3. Cut out the rear panel trim in the area of the display instrument before attaching the cover (arrow).
  4. When attaching the cover with display instrument, route the connection cable to the left under the cover and in the trunk, route downwards to the control module installation point.

    IMPORTANT Tie connection cable to existing cables or wiring looms. Pay attention to chafe-free routing and attach chafe protection if necessary.

    Fig 2: Locating Rear Panel Trim Cut Out Area
    G04743756
scientia non olet · About LEMON Manuals