Installing control module - AZ54.65-P-0001-04G
Model 170.4
The installation described below is not binding and only represents a possible installation example. The choice of installation point depends on the vehicle equipment. If possible the installation point should be selected so that the control module can be installed with the connection point at the bottom.
- Attach the control module (3) to the side panel brace in the left of the trunk and mark the control module mounting holes on the brace.
- Drill through the marked drilling points to 6.5 mm dia.
- Screw the control module (3) onto the side panel brace with 2 screws (1) and spring nuts (2).