Retrofitting Traffic Pro wiring harness - AZ82.61-P-0002-01C

Model 170 up to 30.6.99 

1. Route lead in vehicle along existing wires as shown in figure.
2. Provide gray/yellow (gr/ge) lead for reverse lamp signal with contact spring.
   Fig 1: Identifying Wiring Harness Route

   
3. Insert contact spring of lead for reverse lamp signal (2) into radio connector (A), chamber 2.
   Fig 2: Identifying Radio Connector

   
4. Route gray/yellow (gr/ge) lead for reverse lamp signal from radio shaft to shift gate.
5. Check gray/yellow (gr/ge) lead from reverse lamp switch from standard wiring harness and expose.

   If wire colors deviate, refer to wiring diagram.

6. Solder gray/yellow (gr/ge) lead for reverse lamp signal to gray/yellow (gr/ge) lead from standard wiring harness and insulate.
   Fig 3: Identifying Wiring Harness Route

   
7. Route antenna extension lead (11) in right footwell to right wiring duct as shown in figure.
   Fig 4: Identifying Antenna Extension Lead

   
8. Route lead (11) to rear in right wiring duct.
9. Route lead (11) through rear wall into trunk.
   Fig 5: Identifying Right Wiring Duct Route

   
10. Route lead (11) in trunk on right to trunk lid as shown in figure and fasten with cable straps (arrows).
11. Fasten connector (12) with adhesive felt in trunk lid.
    Fig 6: Identifying Cable Straps And Fasten Connector

    
12. Connect antenna extension lead (11) to navigation system as shown in figure.
    Fig 7: Identifying Antenna Extension Lead