Removing and installing rear brake control cable - AR42.20-P-0525A
MODELS 129, 140, 170, 202, 208, 210
  |
Removing, installing |
|
|
| 1 |
Remove brake shoes of parking brake |
|
AR42.20-P-0530A |
| 2 |
Detach return spring (94) |
Models 129, 140, 170, 202, 208, 210 |
|
| 3 |
Slacken adjusting screw (89) |
Models 129, 170 |
|
| 4 |
Detach front brake cable (85) from intermediate lever (91) |
Models 140, 170, 202, 208, 210
Models 129, 170
 Installation:
Replace self-locking bolt (93). |
|
| 5 |
Detach brake cables (86) from equalizer arm (92) |
|
|
| 6 |
Detach brake cables (86) from frame floor |
Models 129, 140 |
|
| |
|
Models 170, 202, 208, 210:
Use snap-release tool (043).
The brake cable can also be removed by breaking the clamping ring (84). To install, insert a new clamping ring in the groove in the brake cable. |
Fig 2 |
| 7 |
Unscrew self-locking bolt (98) on wheel carrier. |
Installation:
Replace self-locking bolt (98). |
|
| |
|
 |
*BA42.20-P-1002-01A |
| 8 |
Remove brake control cable (86) |
|
|
| 9 |
Install in the reverse order |
|
|
PARKING BRAKE
| Number |
Designation |
Model 129 |
Model 140 |
Model 170 |
| BA42.20-P-1002-01A |
Self-locking bolt, brake cable to rear wheel carrier |
Nm |
20 |
20 |
20 |
PARKING BRAKE
| Number |
Designation |
Model 202 |
Model 208 |
Model 210 |
| BA42.20-P-1002-01A |
Self-locking bolt, brake cable to rear wheel carrier |
Nm |
20 |
20 |
20 |