Bolted connection of tensile strut to wheel carrier modified - BT35.20-P-0008-01A

MODEL 129, 170, 202, 208 as of 1.2.98,210 as of 1.1.98 

Phased in as of 01/98 or 02/98 the bolted connection of the torque strut to wheel carrier has been modified.

The M12 fitted bolt has been replaced by an M12 Torx bolt and the pot-shaped washer has also been replaced by a molded washer.

The tightening torque of 70 Nm is retained.

If a new torque strut is installed on a previous version of the wheel carrier (attachment bore diameter in wheel carrier approx. 13.5 mm), it is absolutely essential to install the sleeve in the wheel carrier to reduce the diameter to approx. 12.2 mm.