Modulating pressure control solenoid valve, ME-SFI fault code description - AD07.61-P-4000-36M
Transmission 722.6
| Modulating pressure control solenoid valve (Y3/6y1) | ||
|---|---|---|
| 1 | Fault code (fault code according to OBD) |
P2063 (P0748) |
| 2 | Fault storage | After expiry of test duration and fault |
| Actuation of engine diagnosis indicator lamp (EURO4) or CHECK ENGINE (MIL) |
Following two successive driving cycles with faults | |
| 3 | Checking frequency | Continuous |
| 4 | Checked signal or status | Actuation of control solenoid valve, modulating pressure |
| 5 | Fault setting conditions | |
| Short circuit to ground | Fault if voltage is less than 0.4 V. | |
| Lower limit value, voltage | ca. 8.5 V | |
| Upper limit value, voltage | ca. 15 V | |
| Lower limit value, current | Approx. 0.3 A. | |
| Upper limit value, current | Approx. 0.7 A. | |
| Checking duration | Approx. 1 second | |
| 6 | Faults (actuation line interruption or short-circuit, short-circuit in valve) are detected by the ETC control unit (N15/3) and transmitted via the CAN data bus to the ME-SFI [ME] control unit (N3/10). Fault storage and actuation of the CHECK ENGINE indicator lamp (MIL) take place via the ME-SFI [ME] control unit. Also read out ETC [EGS] fault memory. |