CAN fault detection ME-SFI - fault code description - AD07.61-P-4000-32MN

1	Fault code (Fault code according to OBD)	P2071 Start enable of DAS not sent (-)
2	Fault storage	After expiry of test duration and fault
	Actuation of engine diagnosis indicator lamp (EURO4) or CHECK ENGINE (MIL)	no activation
3	Checking frequency	At start
4	Checked signal or status	Following initial initialization, the engine control unit and the EIS control unit are permanently assigned. At start, assignment is checked and start enable sent via CAN. Communication between the EIS control unit and the engine control unit is monitored. If a fault occurs, read out the EIS control unit fault memory.
	Checking duration	approx. 10 seconds