Removing and installing traction system control module - AR54.21-P-0816I
MODEL 215, 220
Shown on model 220
| Removal, installation | |||
| 1 | Connect quiescent current retention unit | AR54.10-P-1030-07I | |
| 2 | Disconnect ground lead from battery | AR54.10-P-0003I | |
| 3 | Open engine hood and move to upright position | AR88.40-P-1000M | |
| 4 | Release and remove cover on left fuse box (F1) | ||
| 5 | Pull slide locks (1a) on both connectors (1) on traction system control module (N47) out to stop in direction of arrow and remove connectors | ||
| 6 | Disconnect data bus connector (2) from traction system control module | ||
| 7 | Remove traction systems control module (N47) from left fuse box (F1) upwards out of the guides | ||
| 8 | Install in opposite order |