TELE AID switch-on/switch-off characteristics, function - GF82.95-P-2000A

MODEL 129, 202, 208.3, 210 as of 1.6.98, 215, 220 with CODE (347) TELE AID emergency call system (D2B) 

MODEL 140, 210 up to 31.5.98 with CODE (348) TELE AID emergency call system 

MODEL 140, 202, 210, 220 with CODE (930) Taxi emergency call 

Switch-on characteristics 

The TELE AID system is switched on by turning the starter switch (S2)  to circuit 15R. The switch-on procedure is indicated by the indicator lamp (4 s) coming on in the TELE AID pushbutton switch (S93/3)  . Then the system is ready for operation.

After switch-on the emergency call system control module (TELE AID, A35/8)  activates the CTEL transmitter and receiver (A35)  and waits for readiness confirmation of the

• emergency tensioning retractor control module (ETR) with airbag (AB) (N2/2) 

  or depending on vehicle model the

• restraint system control module (N2/7). 

Switch off characteristics 

• TELE AID is switched off when circuit 15R of the starter switch (S2)  is switched off, an emergency call is not activated and the telephone is set to shut-off delay.

  The telephone system can be set to shut-off delay so that it is possible to continue a call for a certain time even with circuit 15R: OFF  .

  • For control of the telephone system TELE AID remains also active during the telephone shut-off delay, however, it is not possible to trigger an emergency call.
    • During an emergency call TELE AID is not switched off before the emergency call is terminated.
• If an authorization is accomplished while switching off circuit 15R it is interrupted and TELE AID then switched off.