Remove/install bottom part of oil pan - AR01.45-P-7555L

ENGINE 137 in MODEL 215, 220 

ENGINE 275 in MODEL 215, 216, 220, 221, 230 

Shown on engine 137 

Fig 1: Identifying Oil Pan Bottom Section And Bolt (Shown On Engine 137)

	Remove/install
1	Drain engine oil	See Engine oil and filter change
		Model 215.376 /379, 220.176 /179, 230.476 /477 /479	AP18.00-P-0101H
		Model 215.378, 220.178/ 878	AP18.00-P-0101L
		Model 216, 221	AP18.00-P-0101SZ
2	Unscrew bolt (2)		*BA01.45-P-1002-01B
			Figure
3	Remove oil pan bottom section (1)	Installation:  Observe sealant flow: ↓
		Notes on sealant path for oil pan	AH01.45-P-0001-01A
			Figure
		Sealant	*BR00.45-Z-1013-01A
4	Install in the reverse order
5	Check engine oil level	The vehicle must be positioned horizontally on the wheels, otherwise false measurements occur: ↓ Perform adjustments to the control system
		Model 215, 220, 230	AR54.30-P-1000-02OPM
		Model 216, 221	AR54.30-P-1000-02OPS
	Risk of accident  caused by vehicle starting off by itself when engine is running. Risk of injury  caused by contusions and burns during starting procedure or when working near the engine as it is running	Secure vehicle to prevent it from moving by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.	AS00.00-Z-0005-01A
6	Run engine and inspect for oil leaks

OIL PAN

Fig 2: Identifying External Torx Set (001 589 76 09 00)

Fig 3: Identifying Squeeze Gun (112 589 00 25 00)