Power window one-touch up/down feature, function - GF72.29-P-3007B

MODEL 215 

Function prerequisites 

• Voltage not too high or too low and
• Circuit 15 ON or circuit 15R ON
• Power windows synchronized 
• Function not inhibited (version coding)

Function 

The one-touch up/down feature is triggered by momentarily pressing the power window switch  past the first catch point in the "close" or "open" direction.

The corresponding left front door control module (N69/1)/right front door control module (N69/2)/rear control module / N22/6)  reads in the switch status and actuates the associated power window motor (M10/3, M10/4, M10/5 or M10/6)  until the position recognition feature  indicates that the window is completely closed or opened.

On non-synchronized  windows the manual up/down feature  is accomplished instead of the one-touch up/down feature.

When the front side window is opened the associated rear side window can be closed only to the short stroke  position.

Function termination 

The one-touch up/down feature is terminated when

• the power window switch is actuated again or
• the pinch protection  actuates while the window is rolling up
• the function prerequisites are no longer fulfilled.