Switching on/off rear vanity mirror lamps, function - GF82.20-P-2015S

MODEL 220 

The left and right rear interior and vanity mirror lamps (E15/10e2, E15/11e2) are located in the rear dome lamps (E15/19, E15/11). The lights have two functions  :

• Illumination of the rear vanity mirrors
• Illumination of the rear passenger compartment (rear dome lamp  )

They are actuated and switched on and off differently depending on the function.

Switching on vanity mirror lights 

• When the vanity mirror is pivoted down the associated light is switched on

Switching off vanity mirror lights 

• The light is switched off as soon as the mirror is pivoted back up or

• automatically when no activity has been present on the bus for 30 minutes

However the lights also act as dome lights  , whereby this function is switched on and off as described elsewhere.

However the following always applies:  If the vanity mirror is pivoted down, the associated light always burns until it is switched off when no activity has been present on the bus for 30 minutes.

Power supply and control of vanity mirror lights 

The vanity mirror lights are supplied with + 12 Volts by the output on the overhead control panel control module (N70). The overhead control panel control module switches this power off when no activity has been present on the bus for 30 minutes. A change-over switch integrated into the rear dome lamps (E15/10, E15/11) switches on/off the lights when the vanity mirror is put down or up. When the mirror is up the dome light function can be actuated, when it is down, the 12 Volt output on the overhead control panel control module mentioned above is connected to the light.

	Switching on/off rear dome lamp, function		GF82.20-P-2020S
	Rear dome lamp, location/purpose/design/function		GF82.20-P-4109S
	Overhead control panel control module, location/purpose/design/function		GF82.20-P-4101S