Retrofitting telephone transmitter/receiver - AN82.70-P-0001-05ME
- Unscrew sheet metal nuts (23) and sheet metal screw (24).
- Remove control module plate (22) from floor.
Control module plate (22) is not longer required and is replaced with a new one.
- If control module is attached to old control module plate (22), this must now be attached to new control module plate.
- Place D2B telephone transmitter/ receiver (A35/13) onto new control module plate (22) as shown in illustration and attach using 2 bolts M6x12 (25).
- 4 Attach black, 47-pin connector (27) and black, 12-pin connector (2) to D2B telephone transmitter/receiver (A35/13).
- 5 Attach fiber optical cable connector (28) to D2B telephone transmitter/receiver (A35/13).
- 6 Attach control module plate (22) to floor of vehicle using sheet metal screw (24) and sheet metal nuts (23).
Do not overstretch or bend D2B fiber optical cable.