Remove/install spring link and replacement of rubber mount - AR35.20-P-0114MC

MODELS 220.175 /178 with CODE (Z04) Light armoring 

Fig 1: Identifying Spring Link Remove/Install Components - Model 220.175 /178 With Code (Z04) Light Armoring

	Remove/Install
Danger!	Risk of death  cased by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
Installation	Replace self-locking nuts and bolts
1	Raise vehicle.
2	Detach spring strut (41) from spring link (6)		*BA32.25-P-1005-04B
3	Detach spring link (6) from wheel carrier	Installation:  The rear axle shaft must be horizontal when tightening the nut.	*BA35.20-P-1002-01B
4	Detach spring link (6) from rear-axle carrier	Installation:  The rear axle shaft must be horizontal when tightening the nut.	*BA35.20-P-1001-01B
5	Remove spring link (6)	Clean spring link in contact area. After replacing the rear spring or the rubber mount ↓
		Check and correct headlamp adjustment	AP82.10-P-8260A
	Check
6	Inspect spring link rubber mount (6b) in rear axle carrier	↓ If necessary after checking:
		Remove/install spring link rubber mount	AR35.20-P-0114-01I
		Press	Figure
		Removal and installation tool	Figure
7	Install in the reverse order

STRUTS

Number	Designation		Model 220.025/026/028/063/065/067/070/073/074/075/125/126/128/163/165/167/170/173/174/175/176/178/179/875/878
BA32.25-P-1005-04B	Nut, rear spring strut to spring link	Nm	110

SPRING LINK

Number	Designation		Model 220 with CODES Z04, Z07
BA35.20-P-1001-01B	Self-locking nut, track control arm to rear subframe	Nm	120
BA35.20-P-1002-01B	Self-locking nut, spring link to wheel carrier.	Nm	120

Fig 2: Identifying Removal And Installation Tool (220 589 01 43 00)

Fig 3: Identifying Press (202 589 04 43 10)