Installing differential side gears and differential bevel gears - AR35.31-P-0560-04A

Fig 1: Identifying Spring Compressor (116 589 18 61 00)

Fig 2: Identifying Spring Compressor (123 589 06 15 00)

Fig 3: Identifying Spring Compressor (126 589 02 15 00)

Insert assembly arbors (046) into drill holes of differential housing.
Mount both rear axle side gears (17) with thrust plates (18) on the assembly arbor (046) in the differential case.

Fig 4: Mounting Both Rear Axle Side Gears With Thrust Plates On Assembly Arbor In Differential Case
Insert the two differential pinions (15) and spherical washers (14) together and exactly opposite in the differential case and position using assembly arbor (046).

Fig 5: Inserting Differential Pinions And Spherical Washers Together And Exactly Opposite In Differential Case And Position Using Assembly Arbor
Instead of the differential pinion shaft, push the assembly arbor (021) for fixing differential pinions (15) and spherical washers (14) in position into the differential case.
With 185 mm dia. ring gear, use assembly arbor (021)123 589 06 15 00.

With 198 mm dia. ring gear, use assembly arbor (021)126 589 02 15 00.

Fig 6: Pushing Assembly Arbor For Fixing Differential Pinions And Spherical Washers Into Differential Case