Prepare to retrofit battery frame - AN54.10-P-0002-01I
COMMERCIALLY AVAILABLE TOOLS
| Number | Designation |
|---|---|
| WH58.30-Z-1001-03A | Round wire brush, braided, dia. 70 mm |
| WH58.30-Z-1004-20A | Hot-air gun |
| WH58.30-Z-1005-20A | Replacement scraper for heat gun |
| WH58.30-Z-1001-40A | Tarp (fire-resistant) |
WORKSHOP EQUIPMENT
| WE58.40-Z-1001-02A | Inert gas welder |
| WE58.40-Z-1001-03A | Drill (electric/pneumatic) |
| WE58.40-Z-1003-03A | Angle grinder (electric/pneumatic) |
| WE58.40-Z-1005-03A | Wet/dry vacuum cleaner |
- Position battery frame (1) in trunk.
Edge of mount (1a) should be flush with edge of longitudinal member.
- Mark holes to be drilled (2, 3, 4).
- Remove battery frame.
- Drill holes (2, 3, 4) with Ø 6.5 mm dia. bit.
- Remove insulating mats in area of contact surface of battery frame.
- Remove U-guard from rear of drill holes (2, 3).
- Insert M6 x 16 screws in rear wheelhouse to trunk and weld on.
- Insert M6 x 16 screws in trunk floor to trunk and weld on.
- Apply corrosion protection to hole (4).
- Position M6 box nut on hole (4).
- Vacuum clean trunk.