Removing and installing side air vent - AR68.10-P-1100M

MODEL 220 

Fig 1: Identifying Side Air Vent Remove/Install Components - Model 220

Fig 2: Identifying Mounting Nuts For Molding Location

	Removal, installation
	Driver's side
1	Pry molding (6) out of insert clips (4) on instrument panel (5) in area of left air vent (2) with long wedge	Do not remove molding
			Figure
2	Remove molding grille (3) for left air vent (2) upward
3	Pry side air vent (7) for left front door out of instrument panel (5) with long wedge		Figure
4	Remove paneling on A-pillar		AR68.30-P-4050M
5	Unscrew screws (1)
6	Remove air vent (2) from air duct
7	Disconnect connector for air vent (2) illumination	Illumination cannot be replaced or repaired
	Passenger side
8	Remove glove compartment		AR68.10-P-1400M
9	Unscrew mounting nuts for molding (6) in area of glove compartment (arrows)	Molding (6) is screwed onto instrument panel (5) from rear in area of glove compartment
10	Pry molding (6) out of insert clip (4) on instrument panel (5) in area of right air vent (2) with long wedge		Figure
11	Remove molding grille (3) for right air vent (2) upward
12	Pry side air vent (7) for right front door out of instrument panel (5) with long wedge		Figure
13	Remove paneling on A-pillar		AR68.30-P-4050M
14	Unscrew screws (1)
15	Remove air vent (2) from air duct
16	Disconnect connector for air vent (2) illumination	Illumination cannot be replaced or repaired
17	Install in opposite order

Fig 3: Identifying Long Wedge (115 589 03 59 00)