Retrofit antenna - AN82.62-P-0001-02IA
The antenna line is located in the wiring harness (8) which is routed through the cable reel (7). It does not have to be retrofitted.
- Open trunk lid, release bracket (1) and remove hazard warning triangle (2) from mounting.
- Release bracket (1), slide to left and remove.
- Unclip cover (3).
- Remove inner paneling (4) on trunk lid.
- Insert CTEL antenna (A2/22) in direction of arrow.
- Insert plug-in connector (5) to antenna.
- Insert spreader clip (6).
- Route wiring harness (7) into trunk until the antenna's branch-off line is reached.
- Route antenna line to the cable fastener (9), contact it and clip into the cable fastener.