Remove and install bench - AR91.12-P-1010GK

MODELS 163.136/154/172 as of 1.9.9 163.113/128/157/174/175 60 % bench seat

Fig 1: Bench Seat Replacement Components With Torque Specifications

G04609346

	Remove/install
1	Remove headrest	See owner's manual
2	Remove covering (4) on bottom of rear seat	Remove covers only from the 60% bench seat.	AR91.12-P-1100GH
3.1	Disconnect plug to seat belt buckle cable	Only with side airbag on the left and right rear sides, code 293. Turn ignition key to the "0" position to avoid fault codes.
4	Remove bolts (2) and nuts (3) for rear seat fastening	Installation: Replace bolts and nuts with locking agent applied.
			*BA91.12-P-1005-03A
		Torx bit set	Figure
5	Remove bolts at rear of 40% seat bench	Due to seat frame overlap.
			*BA91.12-P-1005-03A
6	Remove 60 % rear seat bench	Remove through the tailgate.
7	Install in the reverse order

TORQUE SPECIFICATION

Rear seats

Number	Designation		Model 163 as of 09/99
BA91.12-P-1005-03A	Nuts for rear seat console on vehicle floor	Nm	40

Fig 2: Identifying Torx Bit Set (000 589 01 10 00)

G04609347