Remove/install front brake control cable - AR42.20-P-0520GH
MODEL 163
Modification notes
| 12.12.02 | Notes on safety for lifting platform, included for the first time | AS00.00-Z-0010-01A | |
| 12.12.02 | Check version of pedal assembly, included for the first time | Step 10 | BT42.20-P-0510-01A |
| Remove/Install | |||
|---|---|---|---|
| Lethal injuries are possible if vehicle slips off of lifting platform | Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| 1 | Pre-tension automatic cable slack adjuster | AR42.20-P-0520-01A | |
| 2 | Detach brake cable (85) at intermediate lever (91) and detach at vehicle floor using snap-release tool (043) | Figure | |
| 3 | Remove cover below instrument panel | AR68.10-P-1500GH | |
| 4 | Remove front floor covering | AR68.20-P-2040GH | |
| 5 | Detach brake cable (85) at parking brake pedal (75) using snap-release tool (043) | ||
| 6 | Loosen cover above brake cable (85) in footwell. | ||
| 7 | Pull brake cable (85) through grommet (85b) at transmission tunnel | ||
| 8 | Install in the reverse order | ||
| 9 | Relieve load on automatic slack adjuster. | AR42.20-P-0520-02A | |
| Inspecting | |||
| 10 | Check version of pedal assembly | ||
| Parking brake pedal assembly modified | BT42.20-P-0510-01A | ||
| 11 | Adjust parking brake | AR42.20-P-0540GH |