ETS diagnosis troubleshooting - AD42.35-P-5001A
MODEL 163 with CODE (212a) electronic traction system (ETS)
| Electronic traction system (ETS), location of components | GF42.35-P-0001-07A | ||
| Troubleshooting | |||
| Complaint | Cause | Note | Remedy |
| ETS MIL (A1 e35) or ABS MIL (A1 e17) illuminate with engine running | Read out fault memory, HHT | ||
| ETS MIL (A1e35) or ABS MIL (A1e17) comes on while driving and does not go out again | Read out fault memory, HHT | ||
| Low brake fluid level/parking brake indicator lamp (A1e7) comes on while driving and does not go out again. There is also an audible warning sound |
Fault in electronic brake force distribution | Read out fault memory, HHT | |
| ETS MIL (A1 e49) and ABS MIL (A1 e17) come on while driving and go out again | On-board voltage <11V, too many electrical consumers in operation | Test generator (G2), read out fault memory, HHT | |
| Brake pad wear indicator lamp (A1e6), low brake fluid level/parking brake indicator lamp (A1e7), ETS warning lamp (A1e36), ABS MIL (A1e17), or ETS MIL (A1e35) not illuminated when ignition switched on | CAN data bus | Read out instrument cluster fault memory, HHT AD42.35-P-6000-03A | |
| ABS MIL (A1e17) illuminated with engine running after brake test stand or roller dynamometer | Implausible speed signal due to different speeds at front and rear axle | Read out and erase fault memory, HHT | |
| ETS MIL (A1e35) comes on while driving and goes out again after some time (Fault C 15 12 is stored) | Rear wheel brake was temporarily overloaded | Read out and erase fault memory, HHT |