Adjust height at front of tilting/sliding roof - AR77.20-P-1100-03A
TEST VALUES FOR TILTING/SLIDING ROOF
| Number | Designation | MODEL 463 | ||
|---|---|---|---|---|
| BE77.20-P-1001-01B | Height setting | Front: deeper than outer skin of roof | mm | 0 to 1 |
| Rear: higher than outer skin of roof | mm | 0 to 1 | ||
| BE77.20-P-1002-01B | Slip Clutch Tightining Torque | Nm | 6-7 | |
- Open tilting/sliding roof.
- Loosen bolts (5) from both side rails (1) on left and right.
- Close titling/sliding roof.
- Adjust front edge of tilting/sliding roof panel by turning height adjustment screws (arrow) in relation to outer skin of the roof.
Adjust height of both slide rails (1) on left and right.
- Tighten bolts (5) on both side rails (1) on left and right.