Remove/install side window - AR67.30-P-2305SG

MODEL 461 with CODE (ZS4) Special protection version FB4 with CODE (ZS6) Special protection version FB6 with CODE (ZS7) Special protection version FB7 

Fig 1: Identifying Window Lining & Trim

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Side Window, Rubber Seal & Mounting Wedge

Courtesy of MERCEDES-BENZ USA

	Removing
1	Remove cover (5)	The paneling (5) is screwed and fastened with glue connection, detach carefully.
2	Remove window lining (4)
3	Remove splinter protection
4	Affix cup suction tool to side window (1)	Cup suction tool/shackle (for removing and installing windows) gotis://K_67.0_03.0
5	Remove side window (1) with rubber seal (2) from the inside outward with assembly wedge (3)	Carefully remove side window (1); danger of breakage.
			Figure
6	Remove rubber seal (2) from side window (1).	Check side window (1) and rubber seal (2) for damage, replace if necessary.
	Install
7	Install rubber seal (2) on side window (1).
8	Insert assembly cord into retaining groove on rubber seal (2)
9	Apply lubricant to weather seal (2)		*BR00.45-Z-1032-06A
10	Insert side widow (1) from outside into window frame.	Use aid of helper. Cup suction tool/shackle (for removing and installing windows) gotis://K_67.0_03.0
11	Pull out assembly cord to window starting at bottom	Press on side window (1) and ensure that rubber seal (2) of side window (1) is seated correctly
12	Clean side window (1) from inside.
13	Install splinter protection	If required, use new micro-encapsulated bolts. If necessary secure bolts with Loctite 243.
			*BA68.30-P-1010-01B
		Loctite 243	*BR00.45-Z-1033-02B
14	Install window lining (4)
15	Install paneling (5)
16	Clean side window (1) from outside

Fig 3: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA