Remove/install paneling on B-pillar - AR68.30-P-4700GY

MODEL 463.236 /237, 463.243 /245 /246 /248 /249 as of 1.6.04, 463.270 /271, 463.323 /333 as of 1.6.04, 463.341 /346 

Fig 1: Identifying B-Pillar Paneling, Cover And Nut

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Mounting Clamp

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying B-Pillar Paneling And Mounting Clamp

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying Panel

Courtesy of MERCEDES-BENZ USA

Fig 5: Identifying Screw

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove cover (2) and unscrew bolt (3) from belt end fitting		*BA91.40-P-1001-01C
			Figure
2	Unscrew cover (4) and unscrew nut (5) from upper belt guide fitting		*BA91.40-P-1002-01C
3	Remove door rubber seal from B-pillar paneling (1)
4	Press mounting clips (6) on B-pillar paneling (1) off of door bead	Installation:  Remove mounting clips (6) from B-pillar paneling (1) and install on door bead, then install B-pillar paneling (1)
5	Remove B-pillar trim (1)	Press roof paneling upward above B-pillar paneling (1) and remove B-pillar paneling (1) from B-pillar starting at top
6	Pull belt out of B-pillar paneling (1)
7	Disconnect electrical connector from rear bench seat heater switch	Only with code (H11) Heated rear bench seat
8	Install in the reverse order

Fig 6: Identifying Torx Bit Set (000 589 01 10 00)

Courtesy of MERCEDES-BENZ USA