Remove/install front fenders - AR88.10-P-1000GR

MODEL 463.202 /222 /236 /237 /243 /244 /245 /246 /247 /248 /249 /250 /254 /270 /271 /303 /306 /309 /322 /323 /332 /333 /336 /340 /341 /346 

Fig 1: Identifying Front Fender Components

Courtesy of MERCEDES-BENZ USA

Shown on left 

	Remove/install
	Notes on self-locking nuts and bolts	All models	AH00.00-N-0001-01A
1	Open engine hood and raise to vertical position		AR88.40-P-1000GG
2	Remove lamp unit	Model 463.243/ 244/ 245/ 246/ 247/ 248/ 249/ 250 /254 /270 /271 /309 /322 /323 /332 /333	AR82.10-P-4730GR
		Model 463.202 /222 /236 /237 /303 /306 /336 /340 /341 /346	AR82.10-P-4730GY
3	Remove front grille		AR88.00-P-2115GM
4	Remove inner fender (4)
5	Remove vacuum line (15) from vacuum reservoir (16)	Only when removing left fender.	AR28.18-P-0010GR
6	Remove fender flare (5)
7	Unscrew bolts (8) and remove cover (9)
8	Remove air intake grille (3) from left fender	Except for model 463.322/323
9	Remove air intake grate (3) from right fender	Only on model 463.322/323
10	Remove bolts (11) and slide back intake fittings (12) in direction of arrow
11	Loosen clamp (14) and remove hose (13) from elbow fitting.	Except on model 463.322/323 and only when removing right fender.
12	Remove left turn signal lamp (E6/1) and right turn signal lamp (E6/2)	Only on model 463.246/249/271 also disconnect connector from left front side-marker lamp (E6/9) and right front side-marker lamp (E6/10).	AR82.10-P-4725G
13	Remove left front GPS antenna (A2/23)	Only when removing left fender.
14	Remove radio and cell phone antenna splitter (A28/1)	Only when removing right fender Do not remove completely, only remove radio and cell phone antenna splitter (A28/1) below fender and unscrew antenna cable from radio and cell phone antenna splitter (A28/1).
		Model 463.202/ 250/ 254/ 303/ 306/ 309	AR82.70-P-8953GR
		Model 463.222 /236 /237 /243 /244 /245 / 246 /247 /248 /249 /270 /271 /322 /323 / 332 /333 /336 /340 /341 /346	AR82.70-P-8953GM
15	Remove hydraulic line on headlamp range adjustment from fender	If installed.
16	Remove bolts (2)	8 screws
17	Remove bolts (7)	6 screws Pull fender toward front and to side for removal.
18	Install in the reverse order