LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2003 >> G500 >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting & Wiper/Washer-- Maintenance -- G-Class (463) >> Maintenance >> Check setting of high beam - AP82.10-P-8260-02GX

Check setting of high beam - AP82.10-P-8260-02GX

DANGER Risk of death  caused by high voltage at xenon headlamps. Risk of explosion/risk of fire  caused by highly flammable materials in the vicinity of damaged xenon bulbs. Risk of injury  caused by UV light, hot components at xenon headlamps and glass splinters produced by bursting xenon bulbs. Risk of poisoning  caused by inhalation of mercury vapors and by toxic salts and mercury compounds being ingested or coming into contact with skin Do not come into contact with parts that are under high voltage. Persons with active electronic implants  (e.g. heart pacemakers) must never work on xenon headlamps. Switch off entire lighting system. Wear insulated safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure sufficient ventilation in the working area. AS82.10-Z-0001-01A
  1. INSPECT Check low beam setting.

    IMPORTANT The center of the light beam must lie on the central mark (6) in the headlamp aimer.

    IMPORTANT Do not perform any correction at the adjustment screws of the headlamps, as in the process the previously adjusted low beams is adjusted again

    INSPECT Vehicles without xenon headlamp unit: In the event of a deviation check the correct seat of the bulb in the headlamp.

Fig 1: Identifying Central Mark In Headlamp Aimer
G07450721Courtesy of MERCEDES-BENZ USA
scientia non olet · About LEMON Manuals