LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2003 >> E55 >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Electrical System - Body - Trouble Diagnosis - 211 Chassis >> Trouble Diagnosis >> Static noise from speakers and COMAND subsequently shuts off and on without obvious cause - AF82.62-P-1061BG

Static noise from speakers and COMAND subsequently shuts off and on without obvious cause - AF82.62-P-1061BG

MODEL 211 with CODE (527) COMAND APS (with navigation) 

OPERATION NO. OF OPERATION TEXTS OR STANDARD TEXTS AND FLAT RATES

Category Op. no. Operation text Time Acc. no. Code
P 024352 Replace fiber optical cable between AGW and navigation processor, MODEL 211.0 013 WU - -
P 024352 Replace fiber optical cable between AGW and navigation processor, MODEL 211.2 008 WU - -
Damage code Cause Remedy  
59 532 74 Fiber optical cable is not sufficiently dampened between audio gateway (AGW) and navigation processor. 1 Read out serial number of AGW using STAR DIAGNOSIS.
↓		  
  IMPORTANT Static noise from all speakers in all audio sources and COMAND subsequently shuts off and on without obvious cause. IMPORTANT
  • "Select model"
  • "Information/communication"
  • "Audio/video/navigation"
  • "AGW"
  • "Control module version"

IMPORTANT Affect are those AGWs up to following serial numbers:
AGW base:
USA/Export A 211 827 43 42 6032 3 1022496 AGW sound:
USA/Export A 211 827 46 42 6035 3 1072438
IMPORTANT If the serial number is less than the ones cited above: ↓
2 Extend fiber optical cable between AGW and navigation processor. To do this:
↓		  
    3 Put together the retrofit wiring harness.
IMPORTANT Use retrofit wiring harness as per the parts ordering notes.
Line A 211 540 68 33 is already present in the vehicle.		  
    4 Detach fiber optical cable.
IMPORTANT Remove the number "16" fiber optical cable from the plug housing on the AGW and navigation processor.		  
    5 Install retrofit wiring harness.
IMPORTANT Install retrofit wiring harness underneath the AGW between the insulation and the frame to the front (see figure).
Make sure that the kink protection device is clipped into the plug housing.		  
    6 Tape disabled fiber optical cable to the other cables.
IMPORTANT To prevent rattling noises.		  
    7 Install retrofit wiring harness between AGW and navigation processor.
IMPORTANT When swinging the navigation processor back in, the fiber optical cable must be held facing forwards in the direction of the insulation so as to avoid it from being kinked and or from it being bent beyond the allowable bending radius.		  
    IMPORTANT To ensure that the MOST ring is a closed circuit again:
↓
8 Start COMAND.		  
    9 Check the map display and the audio source in the "Navigation".  
Fig 1: Identifying Head Unit (HU) And CD Changer (CDC)
G04987563
PARTS ORDERING NOTES

Part no. Designation Quantity
A 211 440 92 05 Retrofit wiring harness 2
scientia non olet · About LEMON Manuals