Detach/install link rod at torsion bar - AR32.20-P-0300-02VM

FRONT AXLE STABILIZER BAR

Number	Designation			Model 211.08/09/28/29
BA32.20-P-1002-02B	Self-locking nut of connecting rod to torsion bar	M10	Nm	-
		M10x1.5	Nm	-
		M12x1.5	Nm	95
		M14x1.5	Nm	-

Removal

Unscrew self-locking nut (01) and bolt (02) of link rod (10) at stabilizer bar (11).
Checking
Check rubber mount of link rod (10) for damage and replace link rod (10) if necessary.
Install
Screw on self-locking nut (01) and bolt (02) of link rod (10) on stabilizer bar (11) .

Fig 1: Identifying Self-Locking Nut, Bolt, Link Rod And Stabilizer Bar

Replace self-locking nut (01). Only tighten self-locking nut (01) when vehicle is ready to drive, turn steering if necessary.