Remove/install trim on B-pillar - AR68.30-P-4700T
MODEL 211.0/ 2
Shown on Model 211.0
Shown on Model 211.0
MODIFICATION NOTES
| 25.7.03 | Step added | Step 17 |
| Removal | |||
|---|---|---|---|
| 1 | Move seat forward and raise rear of seat | ||
| 2 | Remove cover (1) from front seat with mounting wedge (9) | Figure | |
| 3 | Remove bolt (2) and remove belt end fitting | ||
| 4 | Remove edge guard (3) in area of B-pillar trim (8) on both sides | ||
| 5.1 | Remove air inlet vent (4) from B-pillar trim (8) | On vehicles with code (581b) Comfort automatic air conditioning | |
| 6 | Remove front door sill trim (10) and rear door sill trim (11) | ||
| 7 | Press B-pillar trim (8) off of clips (5, 6) on B-pillar with mounting wedge. | Figure | |
| 8 | Move seat belt (7) through B-pillar trim (8) | ||
| 9 | Remove clips (5) from B-pillar | Figure | |
| 10 | Remove clips (6) from B-pillar trim (8) | ||
| Installation | |||
| 11 | Insert clips (6) into B-pillar | ||
| 12 | Insert clips (5) into B-pillar trim (8) | ||
| 13 | Move seat belt (7) through B-pillar trim (8) | ||
| 14 | Clip B-pillar trim (8) to B-pillar | Ensure that clips (5, 6) are seated properly. |
|
| 15 | Check function of belt height adjustment on B-pillar | ||
| 16 | Install front door sill trim (10) and rear door sill trim (11) | ||
| 17.1 | Install air inlet vent (4) in combination with B-pillar (8) | On vehicles with code (581b) Comfort automatic air conditioning | |
| 18 | Install edge guard (3) on both sides of B-pillar | ||
| 19 | Insert belt end fitting and fasten with bolt (2) to front seat | *BA91.40-P-1001-01A | |
| 20 | Install cover (1) |
| Number | Designation | Model 211 | |
|---|---|---|---|
| BA91.40-P-1001-01A | Bolt at belt end fitting | Nm | 32 |